Selection and Use of the MCTC-PG Card for Monarch 3000 New System

Selection and Use of the MCTC-PG Card for Monarch 3000 New System

The NICE3000 New can implement CLVC only with the use of the MCTC-PG card. The following figures show the appearance of the MCTC-PG card and its installation on the controller.


Directly insert the J1 terminal of the MCTC-PG card into the J12 terminal of the controller.

 

Monarch PG Card - Echo Elevador Partes Online Shop
Appearance of the MCTC-PG card and its installation on the controller

1. Selection of the MCTC-PG Card

Monarch provides four PG card models, MCTC-PG-A2, MCTC-PG-D, MCTC-PG-E and MCTC-PG-F1 for different encoder types, as described in the following table.
Monarch PG Card Model Table- Echo Elevador Partes Online Shop
Selection of the MCTC-PG card models

2. Terminal Wiring and Description of the MCTC-PG Card

The MCTC-PG card is connected to the controller and the encoder as follows:
The J1 terminal and CN1 terminal of the MCTC-PG card are respectively connected to the J12 terminal of the MCB on the controller and the encoder of the motor.
Different MCTC-PG card models are connected to the MCB in the same way. The connection method to the encoder depends on the CN1 terminal of the model.
The following figure shows the wiring between MCTC-PG-E and the controller.
Wring between MCTC-PG-E - Echo Elevador Partes Online Store
Wring between MCTC-PG-E and the controller
The following table defines the CN1 terminals of different MCTC-PG card models.
Definitions of the CN1 terminals - Echo Elevador Partes Online Shop
Definitions of the CN1 terminals of different MCTC-PG card models

3. Precautions on Connecting the MCTC-PG Card

  • The cable from the MCTC-PG card to the encoder must be separated from the cables of the control circuit and the power circuit. Parallel cabling in the close distance is forbidden.
  • The cable from the MCTC-PG card to the encoder must be a shielded cable. The shield must be connected to the PE on the controller side. To minimize interference, single-end grounding is suggested.
  • The cable from the MCTC-PG card to the encoder must run through the duct separately and the metal shell is reliably grounded.


4. Selection of Adaptable Motor

The main counters of the electrical relationship between the controller and the motor are voltage and current.

  • In general elevator applications, the input mains voltage is 380 V, and the motor voltage can only be equal to or smaller than 380 V. Thus when selecting the NICE3000 New, you can take only the current of the motor into consideration.
  • When the NICE3000 New is designed, a large safety allowance is reserved for the main power module. The controller can run properly within 1.1 times of the nominal output current. During stable running, the maximum output torque is 150% of the rated torque and can reach up to 200% of the rated torque for a short time.

Therefore, for the motor with the rated voltage of 380 V, you can select the controller of the same power class. As long as the rated current of the motor is smaller than 1.1 times the output current of the controller, the controller of the same power class can also be used.
Generally speaking, when selecting an adaptable motor, ensure that the rated current of the motor is equal to or smaller than the output current of the controller.

Regresar al blog

Deja un comentario

Ten en cuenta que los comentarios deben aprobarse antes de que se publiquen.